Install Sd Card; Installation Procedure - Honeywell Thor VM1 User Manual

Install SD Card

An SD card slot is provided for storage expansion.
Equipment Required
The following equipment is user-supplied:
• Torquing tool capable of measuring inch pounds
• SD card - The following commercially available SD cards are recommended:
®
» Transcend 2GB Industrial SD card (80X Speed) - TS2GSD80I
» ATP 4GB Industrial Grade SDHC card - AF4GSDI
• #2 Phillips screwdriver bit

Installation Procedure

1. For convenience, the Thor VM1 can be removed
from the Quick Mount Smart Dock, though it is not
necessary.
2. If the Thor VM1 remains in the dock, disconnect the
power cable from the dock.
3. Place the Thor VM1 in Suspend by pressing the
Power button.
4. Place the Thor VM1 face down on a stable surface.
5. Using a #2 Phillips bit loosen the M3 screws and
then remove the tethered access panel with the
SIM label. This panel is on the right hand side
when the Thor VM1 is face down with the top away
from the user.
6. Locate the SD card installation slot.
7. Slide the SD card into the slot. The label side (front) of the SD card faces toward the back of the
Thor VM1.
8. Reattach the access panel, torquing the screws to 4-5 inch pounds.
9. If removed, reinstall the Thor VM1 in the dock.
10. Resume the Thor VM1 from suspend.
11. When using Windows explorer to view My Device, the SD card is identified as SD Card. Some
versions may label it Storage Card instead.
4 - 42