Philips Sopho 2000 IPS User Manual page 731

A
CM76 Assign the data for interpreting the digits re-
ceived.
CM90 Assign a Trunk-Direct Appearances key to
term
each D , as required.
CM35 Assign a trunk access code sent to SMDR for
outgoing call.
NOTE: This command is effective when
CM35 Y=189 is not assigned.
Assign a trunk access code for Trunk-Direct
Appearances Multiline Operation.
CM41 Specify the Timing Start when making ISDN
call from a Single Line Telephone (PB/DP),
term
D or Attendant Console.
Specify the ORT timer when sending LCR.
NOTE: Second data 02 is available for
Series 3600 or later.
B
DESCRIPTION
TRUNK-DIRECT APPEARANCES
• Y=01 Day Mode
• Y=02 Night Mode
• Y=03 Mode A
• Y=04 Mode B
(1) 000-999: Number Conversion Block No.
(2) X-XXXXXXXX: Station No. to be termi-
DXX: Change Terminating System to:
D02: Trunk-Direct Appearances
D03: Trunk-Direct Appearances+
D06: Direct-In Termination+
• Y=00
(1) My Line No. +
(2) D000-D255: Trunk No.
• Y=44
(1) 00-63: Trunk Route No.
(2) 00-99: Trunk Access Code
• Y=189
(1) 00-63: Trunk Route No.
(2) X-XX: Trunk Access Code
X=0-9, A (*), B (#)
• Y=0
(1) 50
(2) 03-14: 3-14 seconds
(1 second increment)
If no data is set, the default setting is 10 seconds.
• Y=0
(1) 111
(2) 02-15: 2-15 seconds
(1 second increment)
If no data is set, the default setting is 7 seconds.
– 713 –
DATA
assigned by CM76 Y=00/90
nated
TAS
Trunk-Direct Appearances
,
+ Key No.
NWA-008845-001 Rev.5.0
NOVEMBER/15/2006
32ch1011.fm