Philips Sopho 2000 IPS User Manual page 667

AP Initialization (PN-AP00-B/PN-AP00-D with MRCA program)
[Series 3300 software required]
This section explains the data assignment to make the AP active.
You can skip the data assignment explained on this section, if one of the following AP related features has
been activated; Station Message Detail Recording (SMDR) with NEAX 2400 IMS Format, Message Cen-
ter Interface (MCI) or Do Not Disturb group set/cancel at specified timing in advance. You can distinguish
whether the AP is active or not by the RUN lamp indication. The RUN lamp flashes on green color when
the AP is in active.
When you install the AP00 the first time, you should assign the data shown below.
START
CM05 Assign an AP number to the AP00 card. The
AP number must match the SENSE switch set-
ting on the AP00 card.
On the AP00 card, set SW1 switch as shown
below.
SW 1
ON
CMDD99 Load the initial data into the AP00 card.
On the AP00 card, set the SW1 switch as
shown below.
SW 1
ON
END
DESCRIPTION
4
3
: POSITION TO BE SET
2
1
AP OFF LINE
4
3
: POSITION TO BE SET
2
1
STATION MESSAGE DETAIL RECORDING (SMDR)
• Y=0
(1) 04-15, 20-31: AP No.
(2) 45: PN-AP00-B/PN-AP00-D card with
INITIAL
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
(1) 0000
(2) CCC
SW1-4 should be set as follows;
ON : The AP No. is 04-15
OFF: The AP No. is 20-31
– 649 –
PROGRAMMING
DATA
MRCA program
NWA-008845-001 Rev.5.0
32ch1010.fm
JULY/01/2006