Philips Sopho 2000 IPS User Manual page 394

A
CM08 Specify the method of starting AMP relay cir-
cuit connection.
NOTE 1: This command is effective only when
the second data of CM08>734 is set
to 0.
NOTE 2: Set the second data to 0 when one
Paging trunk is connected with two
AMP relay circuits simultaneously.
NOTE 3: Set the second data to 1 when one
Paging trunk is connected with mul-
tiple AMP relay circuits or with one
AMP relay circuit.
CM44 Assign the paging function to the DK card or
external equipment interface on the MP card.
CM08 Specify the same Access code condition for
Paging Access and Answer.
CM29 Assign a Numbering Plan Group to each Ten-
ant.
CM20 Assign the access code for Paging Access and
Answer.
B
DESCRIPTION
EXTERNAL PAGING WITH MEET-ME
(1) 735
(2) 0 : To connect with two AMP relay cir-
cuits
1 : To connect with one AMP relay circuit
(1) XX Y
XX: 00-31: DK Card No. assigned by
CM10/CM14 (E800-E831)
Y : 0-3: Circuit No. of DK card
313: Built-in External
Equipment Interface
(2) 02XX: Speaker Paging Start
XX : 00-09: Speaker Paging Zone 0-9 as-
(1) 157: Access code for Paging Access and
Answer
(2) 0: Same
(1) 00-63: Tenant No.
(2) 710-713: Numbering Plan Group 0-3
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) A070-A079: For Paging Answer (Zone 0-
– 376 –
DATA
signed by CM20 Y=0-3: A070-
A079/CM30 Y=28
9)
NWA-008845-001 Rev.5.0
32ch1006.fm
JUNE/01/2007