Philips Sopho 2000 IPS User Manual page 388

(2) To provide External Paging from Tie Line
[Series 3700 R12.2 software required]
When one Paging trunk is connected with one AMP relay circuit.
START
CM14 Assign the Paging Trunk (COT card and DK
card) to the required LEN.
NOTE 1:
CM08 Specify ON/OFF condition for external relay/
external key on MP built-in DK00 card.
CM44 Assign the paging function to the DK card or
external equipment interface on the MP card.
CM29 Assign a Numbering Plan Group to each Ten-
ant.
CM20 Assign the access code for Paging Access and
Answer.
A
DESCRIPTION
The DK card number must be as-
signed to the first LEN (Level 0) and
the third LEN (Level 2) of each LT
slot.
EXTERNAL PAGING WITH MEET-ME
(1) XX ZZZ: LEN
XX : 00-59: FP No.
ZZZ: 000-127: Port No.
(2) D000-D255 : COT card
E800-E831
For FP No. 00: E800-E807
For FP No. 01: E808-E815
For FP No. 02: E816-E823
For FP No. 03: E824-E831
NOTE 2:
(1) 700
(2) 0 : ON (Ground Start)
OFF (Ground Off [Open])
1 : ON (Ground Off [Open])
OFF (Ground Start)
(1) XX Y
XX: 00-31: DK Card No. assigned by
CM14 (E800-E831)
Y : 0-3: Circuit No. of DK card
(2) 02XX: Speaker Paging Start
XX : 00-09: Speaker Paging Zone 0-9 as-
(1) 00-63: Tenant No.
(2) 710-713: Numbering Plan Group 0-3
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) 100-163
– 370 –
DATA
: DK card
Circuit No. 3 of E831 is used for
built-in External Equipment In-
terface of MP card by setting
CM44.
signed by CM30 Y=28
: For Paging Access (Trunk
Route 00-63)
NWA-008845-001 Rev.5.0
32ch1006.fm
JUNE/01/2007