How To Read This Manual - Philips Sopho 2000 IPS User Manual

HOW TO READ THIS MANUAL

Chapter 1 and Chapter 2 explains the feature programming for each service feature about the following
items.
PROGRAMMING
This section explains the programming procedure for each service feature.
The meanings of (1), (2) and marking are as follows.
(1) : 1st data
(2) : 2nd data
: Initial data; With the system data clear command (CM00, CM01), the data with this marking is au-
tomatically set for each command.
INITIAL : A reset of the MP card is required after data setting.
Press SW1 switch on the MP card.
AP00 INITIAL : A reset of the AP00 card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
CFT INITIAL : A reset of the CFTC card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
DTI INITIAL : A reset of the DTI card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
CIR INITIAL : A reset of the CIR card is required after data setting.
Set the Make Busy switch to UP and then DOWN.
OFF LINE : Command with this marking can be used only under Off-Line mode of the MP card.
To set Off-Line mode,
(1)
(2)
AP OFF LINE : Command with this marking can be used only under Off-Line mode of the AP00
card.
Set SW3 on the MP card to "2" or "3".
Press SW1 on the MP card.
– 5 –
INTRODUCTION
HOW TO READ THIS MANUAL
NWA-008845-001 Rev.5.0
32ch0001.fm