Suzuki Grand Vitara 2011 Manual page 680

1D-190 Engine Mechanical: For F9Q Engine
d) Insert oil jet into pushrod (1), and install pushrod
to plate (2) facing oil jet with center of cylinder.
e) Using hammer, tap pushrod until pushrod (1)
comes into contact with plate (2).
[A]: Oil jet No.2 and No.4
f) Remove special tools.
3) Using special tool, install main bearing to cylinder
block and bearing cap as follows.
NOTE
One of two halves of main bearing has oil
groove. Install main bearing with oil groove
to cylinder block, and the other one without
oil groove to bearing cap.
Special tool
(A): 09913–86510
a) Install special tool (A) to cylinder block (1).
I5JB0B140120-01
[B]: Oil jet No.1 and No.3
I5JB0B140121-01
b) Fit main bearing (1) in special tool (A) as shown
in figure, and then press bearing end "a" until it
becomes flush with cylinder block.
c) Install special tool (A) to bearing cap (1).
d) Fit main bearing (1) in special tool (A) as shown
in figure, and then press bearing end "a" until
becomes flush with main bearing cap.
I5JB0B140122-01
I5JB0B140123-01
I5JB0B140124-01