Suzuki Grand Vitara 2011 Manual page 630

1D-140 Engine Mechanical: For F9Q Engine
7) Remove cylinder head cover bolts evenly and
gradually in numerical order ("1" through "3") as
shown in figure.
8) Remove cylinder head cover (1), cylinder head cover
gasket (2) and cylinder head cover bolt gaskets (3).
Installation
1) Remove oil and dust from sealing surfaces on
cylinder head and cylinder head cover.
2) Install cylinder head cover (1), new cylinder head
cover gasket (2) and new cylinder head cover bolt
gaskets (3).
3) Tighten cylinder head cover bolts evenly and
gradually in numerical order ("1" through "3") by
repeating tightening sequence two or three times
until specified torque is obtained.
Tightening torque
Cylinder head cover bolt (a): Tighten 12 N⋅m (1.2
kgf-m, 9.0 lb-ft) by the specified procedure
I5JB0B140014-01
4) Install fuel injector cover (1).
Tightening torque
Injector cover bolt (a): 8 N·m (0.8 kgf-m, 6.0 lb-ft)
5) Connect ventilation hose No.2 (2) to ventilation pipe
No.2 (3).
6) Connect ventilation hose No.3 (4) to oil vapor
recirculation valve (5).
7) Install air intake pipe (6) referring to "Air intake Pipe
Removal and Installation: For F9Q Engine".
I5JB0B140015-01
3
2
1
8) Connect CMP sensor connector (1).
I5JB0B140015-01
5
4
6
(a)
1
I5JB0B140016-02
I6JB0A143003-01
I5JB0B140011-01