Chapter 12
Value Added Services (VAS) Traffic Forwarding
How to Enable the Health Check for VAS over 10G Topology
Use this command to configure the health check to adjust to VAS over 10G (MGSCP) conditions (see
Health Check in VAS over 10G Topology, page
•
•
•
Options
The following options are available:
•
How to Enable Health Check Compatibility for VAS over 10G (MGSCP)
Step 1
From the SCE(config if)# prompt, type VAS-traffic-forwarding health-check topology MGSCP and
press Enter.
How to Remove the Health Check Compatibility Configuration
From the SCE(config if)# prompt, type no VAS-traffic-forwarding health-check topology MGSCP
Step 1
and press Enter.
You can also use the default form of the command:
default VAS-traffic-forwarding health-check topology MGSCP
OL-7827-12
Options, page 12-45
How to Enable Health Check Compatibility for VAS over 10G (MGSCP), page 12-45
How to Remove the Health Check Compatibility Configuration, page 12-45
The keyword MGSCP is specified to enable health check compatibility because VAS over 10G is a
special case of a MGSCP (Multi-Gigabit Service Control Platform) system.
–
By default, VAS over 10G compatibility is disabled.
12-39).
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
VAS over 10G
12-45