Configuring the Line Interface
Revised: June 15, 2009, OL-7827-12
Introduction
This module describes how to configure the physical line interfaces (ports) as well how to configure
those interfaces for tunneling, VLAN translation, TOS marking, and traffic rules.
•
•
•
•
•
•
Line Interfaces
The Line Interfaces (Subscriber and Network) are used to connect the SCE platform to the network. See
the description of network topologies in the Topology section of the relevant SCE platform installation
guide
Installation and Configuration
The SCE 1000 2xGBE and the SCE 2000 4xGBE have Gigabit Ethernet line interfaces. You should
configure auto-negotiate for these interfaces.
OL-7827-12
Line Interfaces, page 6-1
Tunneling Protocols, page 6-3
Configuring VLAN Translation, page 6-14
Configuring Traffic Rules and Counters, page 6-17
TOS Marking, page 6-26
Counting Dropped Packets, page 6-27
(Cisco SCE 2000 4xGBE Installation and Configuration Guide
C H A P T E R
Guide.)
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
6
or
Cisco SCE 1000 2xGBE
6-1