Chapter 5
Configuring the Management Interface and Security
Configuring the Management Interface Speed and Duplex Parameters
This section presents sample procedures that describe how to configure the speed and the duplex of the
Management Interface.
Both these parameters must be configured separately for each port.
•
•
•
Interface State Relationship to Speed and Duplex
Table 5-1
Table 5-1
Speed
Auto
Auto
Auto
10
10
10
100
100
100
How to Configure the Speed of the Management Interface
•
•
Options
The following options are available:
•
If the duplex parameter is configured to auto, changing the speed parameter has no effect (see ).
Step 1
From the SCE(config if)# prompt, type speed 10|100|auto and press Enter.
Specify the desired speed option.
OL-7827-12
Interface State Relationship to Speed and Duplex, page 5-5
How to Configure the Speed of the Management Interface, page 5-5
How to Configure the Duplex Operation of the Management Interface, page 5-6
summarizes the relationship between the interface state and speed and duplex.
Interface State Relationship to Speed and Duplex
Duplex
Auto
Full
Half
Auto
Full
Half
Auto
Full
Half
Options, page 5-5
Configuring the Speed of the Management Interface: Example, page 5-6
speed — speed in Mbps of the currently selected management port (0/1 or 0/2):
10
–
100
–
auto (default) — auto-negotiation (do not force speed on the link)
–
Configuring the Management Port Physical Parameters
Actual FE Interface State
Auto negotiation
Auto negotiation
Auto negotiation
Auto-negotiation (duplex only)
10 Mbps and full duplex
10 Mbps and half duplex
Auto-negotiation (speed only)
100 Mbps and full duplex
100 Mbps and half duplex
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-5