Table of Contents
Advertisement
Chapter 5
Configuring the Management Interface and Security
How to Configure the Duplex Operation of the Management Interface
•
•
Options
The following options are available:
•
If the speed parameter is configured to auto, changing the duplex parameter has no effect (see ).
From the SCE(config if)# prompt, type duplex auto|full|half and press Enter.
Step 1
Configures the duplex operation of the currently selected management interface.
Configuring the Duplex Operation of the Management Interface: Example
The following example shows how to use this command to configure both management ports to half
duplex mode.
SCE#config
SCE(config)#interface mng 0/1
SCE(config if)#duplex half
SCE(config if)#exit
SCE(config)#interface mng 0/2
SCE(config if)#duplex half
How to Configure the Speed of the Management Interface
•
•
Options
The following options are available:
•
If the duplex parameter is configured to auto, changing the speed parameter has no effect (see ).
From the SCE(config if)# prompt, type speed 10|100|auto and press Enter.
Step 1
Configures the speed of the currently selected management interface.
OL-7827-12
Options, page 5-71
Configuring the Duplex Operation of the Management Interface: Example, page 5-71
duplex — duplex operation of the currently selected management port (0/1 or 0/2):
–
full
half
–
auto (default) — auto-negotiation (do not force duplex on the link)
–
Options, page 5-71
Configuring the Speed of the Management Interface: Example, page 5-72
speed — speed in Mbps of the currently selected management port (0/1 or 0/2):
10
–
100
–
–
auto (default) — auto-negotiation (do not force speed on the link)
Configuring the Management Port Physical Parameters
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-71
Advertisement
Table of Contents
