Table of Contents
Advertisement
Chapter 12
Value Added Services (VAS) Traffic Forwarding
How to Disable a VAS Server
From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number disable and
Step 1
press Enter.
How to Restore all VAS Server Properties to Default
From the SCE(config if)# prompt, type no VAS-traffic-forwarding VAS server-id number and press
Step 1
Enter.
How to Assign a VLAN ID to a VAS Server
Use this command to assign the VLAN ID to a specified VAS server.
•
•
•
•
•
Options
The following options are available:
•
•
Note the following important points:
•
•
•
How to Configure the VLAN Tag Number for a Specified VAS Server
From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number VLAN vlan-id
Step 1
and press Enter.
OL-7827-12
Options, page 12-21
How to Configure the VLAN Tag Number for a Specified VAS Server, page 12-21
How to Remove the VLAN Tag Number from a Specified VAS Server, page 12-22
How to Configure the Health Check, page 12-22
How to Configure Pseudo IP Addresses for the Health Check Packets, page 12-23
number — The number of the VAS server.
vlan-id — The VLAN tag to use for the specified VAS server
The VLAN tag can be redefined as necessary.
Default — No VLAN.
–
The VAS server is not operational until the VLAN tag is defined.
Disabling the server does not remove the VLAN tag number configured to the server.
The no form of the command (same as the default form of the command), removes the previously
configured VLAN tag (no VLAN is the default configuration).
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring VAS Traffic Forwarding
12-21
Advertisement
Table of Contents
