Chapter 14
Managing the SCMP
Configuring SCMP Parameters
•
•
•
•
•
•
•
You can configure the following options for the SCMP:
•
•
•
•
•
•
•
How to Enable the SCMP
By default, the SCMP is disabled.
From the SCE(config)# prompt, type scmp and press Enter.
Step 1
How to Disable the SCMP
From the SCE(config)# prompt, type no scmp and press Enter.
Step 1
Configuring the SCMP Peer Device to Push Sessions
When SCMP establishes a connection with an SCMP peer device, it informs the device whether the
SCMP is configured to push sessions or to wait till the sessions are pulled by the SCE platform.
Use this command to specify push mode. Use the no form of the command to specify pull mode. This
configuration takes effect only after the connection is re-established.
Default is disabled (pull mode).
Step 1
From the SCE(config)# prompt, type scmp subscriber send-session-start and press Enter.
OL-7827-12
How to Enable the SCMP, page 14-9
How to Disable the SCMP, page 14-9
Configuring the SCMP Peer Device to Push Sessions, page 14-9
Configuring the SCMP Peer Device to Force Each Subscriber to Single SCE Platform, page 14-10
How to Define the Keep-alive Interval Parameter, page 14-11
How to Define the Reconnect Interval Parameter, page 14-11
How to Define the Loss-of-Sync Timeout Parameter, page 14-11
Enable the SCMP
Configure the SCMP peer device to push sessions to the SCE platform
Allow the SCMP peer device to provision each subscriber to only one SCE platform.
Define the SCMP keep-alive interval
Define the SCMP reconnect interval
Define the loss-of-sync timeout
Define the subscriber ID structure
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring the SCMP
14-9