Table of Contents
Advertisement
Chapter 12
Value Added Services (VAS) Traffic Forwarding
How to Configure a VAS Server Group
•
•
•
About VAS Server Groups
The user may define up to eight VAS server groups. Each VAS server group has the following
parameters:
•
•
•
•
Use the following commands to perform these operations for a VAS server group:
•
•
•
How to Add and Remove Servers
Use these commands to add and remove servers to or from a specified VAS server group.
•
•
•
•
Options
The following options are available:
•
•
OL-7827-12
About VAS Server Groups, page 12-25
How to Add and Remove Servers, page 12-25
How to Configure VAS Server Group Failure Parameters, page 12-26
Server Group ID
A list of VAS servers attached to this group.
Failure detection — minimum number of active servers required for this group so it will be
considered to be Active. If the number of active servers goes below this minimum, the group will be
in Failure state.
Failure action — action performed on all new data flows that should be mapped to this Server Group
while it is in Failure state.
Options:
block
–
–
pass
Add or remove a VAS server to or from a specified group.
Configure the minimum number of active servers for a specified group.
Configure failure behavior for a specified group.
Options, page 12-25
How to Add a VAS Server to a Specified VAS Server Group, page 12-26
How to Remove a VAS Server from a Specified VAS Server Group, page 12-26
How to Remove all VAS Servers from a Specified VAS Server Group, page 12-26
group-number — The ID number of the VAS server group
id-number — The ID number of the VAS server
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring VAS Traffic Forwarding
12-25
Advertisement
Table of Contents
