How To Define The Subscriber Notification Setting For A Specific Attack Detector; How To Define The Snmp Trap Setting For A Specific Attack Detector; How To Define The List Of Destination Ports For Tcp Or Udp Protocols For A Specific Attack Detector - Cisco SCE2020-4XGBE-SM Configuration Manual

Chapter 11 Identifying and Preventing Distributed-Denial-Of-Service Attacks

How to Define the Subscriber Notification Setting for a Specific Attack Detector

Use the following command to set the subscriber notification setting for a given attack detector and
selected set of attack types.
Step 1 From the SCE(config if)# prompt, type attack-detector number protocol (((TCP|UDP) [dest-port
(specific|not- specific|both)])|ICMP|other|all) attack-direction
(single-side-source|single-side-destination|single-side-both|dual-sided|all) side
(subscriber|network|both) (notify-subscriber|don't-notify-subscriber) and press Enter.
Defines the subscriber notification setting for the specified attack detector

How to Define the SNMP Trap Setting for a Specific Attack Detector

Use the following command to enable or disable sending an SNMP trap for a given attack detector and
selected set of attack types.
From the SCE(config if)# prompt, type attack-detector number protocol (((TCP|UDP) [dest-port
Step 1
(specific|not- specific|both)])|ICMP|other|all) attack-direction
(single-side-source|single-side-destination|single-side-both|dual-sided|all) side
(subscriber|network|both) (alarm|no-alarm) and press Enter.
Defines the SNMP trap setting for the specified attack detector.

How to Define the List of Destination Ports for TCP or UDP Protocols for a Specific Attack Detector

Use the following command to define the list of destination ports for specific port detections for TCP or
UDP protocols.
From the SCE(config if)# prompt, type attack-detector number
Step 1
(all|(
Defines the port list for the specified protocol and attack detector.
OL-7827-12
port1 port2, port3... and press Enter.
[ ])
TCP-port-list|UDP-port-list
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Configuring Attack Detectors
11-15