Table of Contents
Advertisement
Chapter 13
MPLS/VPN Support
Subscriber pulled: 0.
Subscriber aged: 0.
Pull-request notifications sent: 0.
State notifications sent: 0.
Logout notifications sent: 0.
Subscriber mapping TIR contradictions: 0
Monitoring MPLS/VPN Counters
Use the following Viewer command to display MPLS/VPN information.
Step 1
From the SCE> prompt, type show interface linecard 0 mpls vpn and press Enter.
Monitoring MPLS/VPN Counters: Example
SCE> show interface linecard 0 mpls vpn
MPLS/VPN auto-learn mode is enabled.
MPLS based VPNs with subscriber mappings: 0 used out of 2015 max
Total HW MPLS/VPN mappings utilization: 0 used out of 57344 max
MPLS/VPN mappings are divided as follows:
downstream VPN subscriber mappings: 0
upstream VPN subscriber mappings: 0
non-vpn upstream mappings: 0
downstream bypassed VPN mappings: 0
upstream bypassed VPN mappings: 0
Monitoring the PE Routers
Use the following Viewer commands to monitor PE routers. These commands provide the following
information:
•
•
•
•
How to Display the Configuration of all Currently Defined PE Routers
From the SCE> prompt, type show interface linecard 0 MPLS VPN PE-Database and press Enter.
Step 1
How to Display the Configuration of a Specified PE Router
From the SCE# prompt, type show interface linecard 0 MPLS VPN PE-Database PE-ID pe-id and
Step 1
press Enter.
OL-7827-12
Configuration of all currently defined PE routers.
Configuration of a specified PE router.
How to Display the Configuration of all Currently Defined PE Routers, page 13-23
How to Display the Configuration of a Specified PE Router, page 13-23
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Managing MPLS/VPN Support
13-23
Advertisement
Table of Contents
