Table of Contents
Advertisement
Configuring MPLS/VPN Support
Configuring the SM for MPLS/VPN Support
•
•
how to Configure the SM for MPLS/VPN Support
There are two main steps to configure the SM for MPLS/VPN support:
Edit the p3sm.cfg configuration file to specify the field in the BGP messages that should be used by the
Step 1
SM for MPLS-VPN identification.
See
Install and configure the BGP LEG
Step 2
Refer to the
How to Edit the SM Configuration File
The SM configuration file, p3sm.cfg, must be configured for the following:
•
•
•
•
How to Configure the SM for MPLS/VPN Support
Add the following section to the p3sm.cfg configuration file:
Step 1
# The following section enables SM operation with MPLS-VPN support.
[MPLS-VPN]
# The following parameter defines the BGP attribute to use to identify VPN subscribers
# possible values: "rd" or "rt".
# (default: rt)
vpn_id=rt
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
13-16
How to Edit the SM Configuration File, page 13-16
How to Configure the SM to Allow IP Ranges, page 13-17
How to Edit the SM Configuration File, page 13-16
Cisco SCMS SM LEGs User Guide
To specify the field in the BGP messages that should be used by the SM for MPLS-VPN
identification.
To enable IP ranges
How to Configure the SM for MPLS/VPN Support, page 13-16
How to Configure the SM for Troubleshooting MPLS/VPN Support, page 13-17
for more information.
Chapter 13
MPLS/VPN Support
OL-7827-12
Advertisement
Table of Contents
