Configuring the Connection
Revised: June 15, 2009, OL-7827-12
Introduction
•
•
•
•
•
•
•
•
Configuring the Connection Mode
The connection mode command allows you to configure the topology of the system in one command.
The connection mode is determined by the physical installation of the SCE platform.
This command can only be used if the line card is in either no-application or shutdown mode. If an
Caution
application is installed on the SCE platform, the command will fail with an error message and help
instructions.
•
•
OL-7827-12
Configuring the Connection Mode, page 7-1
Monitoring the Connection Mode and Related Parameters, page 7-3
How to Configure the Link Mode, page 7-5
Configuring Asymmetric Routing Topology, page 7-7
Configuring a Forced Failure, page 7-9
Configuring the Failure Recovery Mode, page 7-9
Configuring the SCE Platform/SM Connection, page 7-10
Enabling and Disabling Link Failure Reflection, page 7-12
Options, page 7-2
Configuring the Connection Mode: Examples, page 7-3
C H A P T E R
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
7
7-1