How To Display All Subscribers Mapped To A Specified Ip Range; How To Display The Number Of Subscribers Mapped To A Specified Ip Range; Configuring The Actual Maximum Number Of Subscribers; How To Override The Configured Capacity Option - Cisco SCE2020-4XGBE-SM Configuration Manual

Chapter 9 Managing Subscribers

How to Display All Subscribers Mapped to a Specified IP Range

From the SCE> prompt, type
Step 1
TP-IP-range

How to Display the Number of Subscribers Mapped to a Specified IP Range

From the SCE> prompt, type
Step 1
TP-IP-range

Configuring the Actual Maximum Number of Subscribers

The actual maximum number of subscribers supported is based on the capacity option specified when
loading the SCA BB application. If no capacity option is specified, the user-configured default capacity
is used. However, you can override this capacity option using the following commands.
Note the following:
•
•
•

How to Override the Configured Capacity Option

The default maximum number of subscribers is 80K.
Step 1 Select the maximum number of subscribers:
From the SCE(config if)# prompt, type subscriber max-subscribers (40K | 80K | 120K | 200K) and
press Enter.
Step 2 :Disable the application capacity option:
From the SCE(config if)# prompt, type subscriber capacity-options disable and press Enter.
Step 3 Install the new application file. (The configured subscriber maximum takes effect only after a new
application file has been loaded.)
OL-7827-12
show interface linecard 0subscriber mapping included-in
ip-address/mask and press Enter.
show interface linecard 0 subscriber amount mapping included-in
ip-address/mask and press Enter.
You must configure the override before you load the application. The configured maximum number
of subscribers takes effect when the next load command is executed.
If you have disabled the capacity option and then the next time you load a new application you want
to use the capacity option, you must re-enable the capacity option before loading the application file
(see How to Restore the Configured Capacity Option, page
Use the show subscriber max-subscribers command to see what the current maximum number of
subscribers is and whether the capacity option is enabled or disabled (see
Maximum Number of Subscribers, page
Configuring the Actual Maximum Number of Subscribers
9-38).
9-38.)
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
How to Monitor the
9-37