Table of Contents
Advertisement
CLI Commands for Cascaded Systems
CLI Commands for Cascaded Systems
•
•
•
This section presents CLI commands relevant to the configuration and monitoring of a redundant system.
Topology-Related Parameters for Redundant Topologies
All four of the topology-related parameters are required when configuring a redundant topology.
•
•
•
•
Configuring the Connection Mode
Use the following command to configure the connection mode, including the following parameters.
•
•
•
•
To configure the connection mode, use the following command.
From the SCE 2000 (config if)# prompt, type connection-mode inline-cascade|receive-only-cascade
Step 1
[physically-connected-links {link-0|link-1}][priority {primary|secondary}] [on-failure
{bypass|cutoff}] and press Enter.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
10-10
Topology-Related Parameters for Redundant Topologies, page 10-10
Configuring the Connection Mode, page 10-10
Monitoring a Cascaded System, page 10-11
Connection mode — Redundancy is achieved by cascading two SCE platforms. Therefore the
connection mode for both SCE platforms may be either:
Inline-cascade
–
Receive-only-cascade
–
Physically-connected-links — For each of the cascaded SCE platforms, this parameter defines the
number of the link (Link 0 or Link 1) connected to this SCE platform.
Priority — For each of the cascaded SCE platforms, this parameter defines whether it is the primary
or secondary device.
On-failure — For each of the cascaded SCE platforms, this parameter determines whether the
system cuts the traffic or bypasses it when the SCE platform either has failed or is booting.
inline/receive only
physically connected links
behavior upon failure of the SCE platform
primary/secondary
Chapter 10
Redundancy and Fail-Over
OL-7827-12
Advertisement
Table of Contents
