Chapter 3
Operations
How to Upgrade an Application
From the SCE(config if)# prompt, type pqi upgrade file filename [options] and press Enter.
Step 1
Upgrades the current application with the specified pqi file using the installation options specified (if
any). Use the show pqi file filename info command to display installation options available for the
application file. (See
Note that this may take up to five minutes.
How to Undo an Upgrade of an Application
From the SCE(config if)# prompt, type pqi rollback file filename and press Enter.
Step 1
Undoes the upgrade of the specified pqi file.
Note that this may take up to five minutes.
How to Display the Last pqi File that was Installed
From the SCE> prompt, type pqi last-installed and press Enter
Step 1
OL-7827-12
How to Display Information about an Application File, page
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Managing Application Files
3-10.)
3-11