Configure SNTP
How to Remove One SNTP Server
Options
The following option is available:
•
From the SCE(config)# prompt, type
Step 1
Removes the specified SNTP unicast server.
How to Define the SNTP Unicast Update Interval
•
•
Options
The following option is available:
•
From the SCE(config)# prompt, type sntp update-interval interval, and press Enter.
Step 1
Configures the SNTP unicast client to query the server at the defined intervals.
Defining the SNTP Unicast Update Interval: Example
The following example shows how to set the SNTP update interval for 100 seconds.
SCE(config)# sntp update-interval 100
How to Display SNTP Information
From the SCE> prompt, type show sntp
Step 1
Displays the configuration of both the SNTP unicast client and the SNTP multicast client.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
5-66
ip-address — the IP address of the SNTP unicast server.
Options, page 5-66
Defining the SNTP Unicast Update Interval: Example, page 5-66
interval — the time in seconds between updates (64 through 1024)
default interval = 900 seconds
Chapter 5
Configuring the Management Interface and Security
ip-address and press Enter
no sntp server
and press Enter.
,
OL-7827-12