Configuring VAS Traffic Forwarding
How to Configure a VAS Server
•
•
•
•
The user must define the VAS servers. Each VAS server has the following parameters:
•
•
•
•
Use the following commands to perform these operations for individual VAS servers:
•
•
•
•
•
•
Note that a VAS server is not operational until the VLAN tag is defined, even if the server itself is
enabled.
Options
The following option is available:
•
How to Enable a VAS Server
Use this command to enable a VAS server.
Note
The server is not operational until a VLAN tag has also been defined
From the SCE(config if)# prompt, type VAS-traffic-forwarding VAS server-id number enable and
Step 1
press Enter.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
12-20
Options, page 12-20
How to Enable a VAS Server, page 12-20
How to Disable a VAS Server, page 12-21
How to Restore all VAS Server Properties to Default, page 12-21
Admin-mode — Enabled or disabled.
Health Check mode — Enabled or Disabled
Health Check ports
VLAN tag
Enable a specified VAS server
Disable a specified VAS server
Define the VLAN tag for a specified VAS server
Enable or disable the Health Check for a VAS server
Define the source and destination ports to use for the Health Check.
Delete all properties for a specified VAS server. The server returns to the default state, which is
enabled. However, it is not operational since it does not have VLAN.
number — The number of the VAS server.
Chapter 12
Value Added Services (VAS) Traffic Forwarding
OL-7827-12