Table of Contents
Advertisement
Chapter 2
Command Line Interface
Figure 2-1
E1
Configuration
The following commands are used to enter the different configure interface modes and the Line
Configuration Mode:
•
E1 interface Linecard 0
•
E2 interface Mng 0/1 or 0/2 (management port, all platforms)
E3:
•
–
–
E4:
•
–
–
E5 line vty 0
•
Although the system supports up to five concurrent Telnet connections, you cannot configure them
Note
separately. This means that any number you enter in the line vty command (0, 1, 2, 3 or 4 ) will act as a
0 and configure all five connections together.
OL-7827-12
CLI Command Modes
Exit
E2
Line Card
Management
Interface
Interface
Configuration
Mode
Mode
Interface Configuration Mode
SCE 1000: interface GigabitEthernet 0/1 or 0/2
SCE 2000: interface TenGigabitEthernet 0/1, 0/2, 0/3, or 0/4
SCE 1000: interface range GigabitEthernet 0/1-2
SCE 2000: interface range TenGigabitEthernet 0/<port-range (any range between 1 and
4)>
User Exec Mode
Enable
Disable
Privileged Exec Mode
Configure
Exit
Global Configuration Mode
Exit
E3
Exit
Interface
Configuration
Mode
(Traffic)
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Authorization and Command Levels (Hierarchy)
E4
Exit
E5
Interface
Range
Configuration
Configuration
Mode
Exit
Line
Mode
2-5
Advertisement
Table of Contents
