Table of Contents
Advertisement
Downgrading the SCE Platform to a Previous Version
Type reload.
Step 5
Reboots the system.
The system first prompts you for confirmation:
Are you sure?
Step 6
Type Y and press Enter.
The system sends the following message and reboots.
The system is about to reboot, this will end your CLI session
Upgrading SCE Platform Firmware: Example
The following example shows the full procedure for performing a firmware update.
SCE#configure
SCE(config)# boot system ftp://vk:vk@10.1.1.230/downloads/SE2000.pkg
SCE(config)#exit
SCE#copy running-config startup-config
Backing–up configuration file...
Writing configuration file...
Extracting new system image...
Extracted OK.
SCE#>reload
Are you sure? y
the system is about to reboot, this will end your CLI session
Downgrading the SCE Platform to a Previous Version
To downgrade a cascaded system, follow the procedure described in
Note
and Application, page
To downgrade the SCE platform to a previous release, complete the following steps
Uninstall the current application.
Step 1
Use the pqi uninstall file command (see
Install the desired firmware version.
Step 2
Use the procedure described in
Install the desired application version.
Step 3
Use the pqi install file command (see
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
3-8
10-13, using the relevant downgrade files rather than upgrade files.
How to Uninstall an Application, page
Upgrading the SCE Platform Firmware, page
How to Install an Application, page
Chapter 3
Operations
Simultaneous Upgrade of Firmware
3-10).
3-7.
3-10).
OL-7827-12
Advertisement
Table of Contents
