Table of Contents
Advertisement
Managing Application Files
The following commands are relevant for installing and uninstalling an application:
•
•
•
•
•
•
How to Display Information about an Application File
From the SCE> prompt, type show pqi file filename info and press Enter.
Step 1
Displays installation options available for this application file, if any.
How to Install an Application
From the SCE(config if)# prompt, type pqi install file filename [options] and press Enter.
Step 1
Installs the specified pqi file, using the installation options specified (if any). Use the show pqi file
filename info command to display installation options available for the application file. (See
Display Information about an Application File, page
Note that this may take up to five minutes.
Always run the pqi uninstall command before installing a new pqi file. (See
Note
Application, page
How to Uninstall an Application
Step 1
From the SCE(config if)# prompt, type pqi uninstall file filename and press Enter.
Uninstalls the specified pqi file.
You must specify the last pqi file that was installed.
Note that this may take up to five minutes.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
3-10
pqi install file (interface linecard configuration mode)
pqi uninstall file (interface linecard configuration mode)
pqi upgrade file (interface linecard configuration mode)
pqi rollback file (interface linecard configuration mode)
show pqi file info (viewer mode)
show pqi last-installed (viewer mode)
3-10.)
3-10.)
How to Uninstall an
Chapter 3
Operations
How to
OL-7827-12
Advertisement
Table of Contents
