Table of Contents
Advertisement
Configuring Traffic Rules and Counters
Example 4
The following example illustrates how to configure a traffic rule that will be used as a recording rule
using the flow-capture option. All flows that match this rule will be recorded when the flow capture
process is in operation.
1.
2.
3.
4.
5.
6.
7.
SCE>enable 10
Password:<cisco>
SCE#configure
SCE(config)#interface linecard 0
SCE(config if)#traffic-rule name FlowCaptureRule ip-addresses subscriber-side all
network-side all protocol 250 direction both traffic-counter name counter2 action
flow-capture
SCE(config if)#
How to Delete a Traffic Rule
From the SCE(config if)# prompt, type no traffic-rule name name and press Enter.
Step 1
Removes the specified traffic rule.
How to Delete all Traffic Rules
From the SCE(config if)# prompt, type no traffic-rule all and press Enter.
Step 1
Removes all existing traffic rules.
How to Delete All Flow Control Traffic Rules
From the SCE(config if)# prompt, type no traffic-rule capture and press Enter.
Step 1
Removes all flow capture traffic rules.
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
6-24
Name = FlowCaptureRule
IP addresses: subscriber side = all IP addresses, network side = all IP addresses
Direction = both
Protocol = 250
Traffic counter name = counter2
Action = flow-capture
The actions performed will be counting and flow capture.
Chapter 6
Configuring the Line Interface
OL-7827-12
Advertisement
Table of Contents
