Table of Contents
Advertisement
Chapter 4
Utilities
You are prompted to continue the setup, depending on the choice you entered:
Step 3
•
•
•
Working with SCE Platform Files
The CLI commands include a complete range of file management commands. These commands allow
you to create, delete, copy, and display both files and directories
Regarding disk capacity: While performing disk operations, the user should take care that the addition
Note
of new files that are stored on the SCE disk do not cause the disk to exceed 70%.
•
•
Working with Directories
•
•
•
•
•
How to Create a Directory
From the SCE# prompt, type mkdir directory-name and press Enter.
Step 1
OL-7827-12
1. Leave the running configuration unchanged:
The dialog proceeds to the next question. The list remains unchanged.
2. Clear the existing entries and configure new ones:
The dialog prompts you for a new entry in the list.
After completing the first entry, you are asked whether you would like to add another new entry.
Would you like to add another SNMP trap manager? [no]: y
Since the list was empty, you may enter the maximum number of entries.
3. Add new entries:
The dialog prompts you for a new entry in the list.
After the completing one entry, you are asked whether you would like add another new entry.
Would you like to add another SNMP trap manager? [no]: y
You may enter only enough additional entries to reach the maximum number
Working with Directories, page 4-5
Working with Files, page 4-7
How to Create a Directory, page 4-5
How to Delete a Directory, page 4-6
How to Change Directories, page 4-6
How to Display your Working Directory, page 4-6
How to List the Files in a Directory, page 4-6
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
Working with SCE Platform Files
4-5
Advertisement
Table of Contents
