Table of Contents
Advertisement
Monitoring the SCMP Environment
Options
The following options are available:
•
•
From the SCE(config)# prompt, type ip radius-client retry limit times [timeout
Step 1
Enter.
Monitoring the SCMP Environment
•
•
You can monitor the following components of the SCMP environment:
•
•
Monitoring the SCMP
•
•
•
•
•
•
Use the following commands to monitor the SCMP. These commands provide the following information:
•
•
•
•
Options
The following options are available:
•
Cisco SCE 2000 and SCE 1000 Software Configuration Guide
14-16
times — The maximum number of times the RADIUS client can try unsuccessfully to send a
message.
Default = 3
–
timeout (optional) — Timeout interval for retransmitting a message, in seconds
Default = 1 second
–
Monitoring the SCMP, page 14-16
Monitoring the RADIUS Client, page 14-18
SCMP
RADIUS client
Options, page 14-16
How to display the general SCMP configuration, page 14-17
How to display the configuration all currently defined SCMP peer devices, page 14-17
How to display the configuration for a specified SCMP peer device, page 14-17
How to display the statistics for all SCMP peer devices, page 14-17
How to display the statistics for a specified SCMP peer device, page 14-18
General SCMP configuration
Configuration of all currently defined SCMP peer devices.
Configuration of a specified SCMP peer device.
Statistics for either all SCMP peer devices or a specified SCMP peer device.
device-name — The name of the specific SCMP peer device for which to display the configuration
or statistics.
Chapter 14
Managing the SCMP
] and press
timeout
OL-7827-12
Advertisement
Table of Contents
