Starting And Shutting Down The Nvr; Starting The Nvr; Shutting Down The Nvr; Device Initialization - Honeywell Performance Series User Manual

Starting and Shutting Down the NVR

Starting the NVR

1. Verify that the NVR is connected to an appropriate power source.
2. Turn on the power switch on the rear panel to start the NVR.
Note: The beep at startup is normal.

Shutting Down the NVR

To shut down the NVR, you must be logged in as the admin user or have
Note:
shutdown privileges assigned to you. See
To prevent damage to the hard drive, follow these steps to shut down the
NVR:
1. In live view mode, click anywhere on the screen to display the
2. In the Main Menu window, click Shutdown.
3. In the Shutdown window, click Shutdown or Reboot.
4. Enter the admin password (the default password is 1234), and then

Device Initialization

•
•
•
1. Boot up NVR.
2. Set region, system time zone, and time according to the actual
Performance Series Embedded NVR User Guide
shortcut menu, and then click Main Menu.
click OK.
If it is your first time to use the Device, set a login password of admin
(system default user). You can select to use unlock pattern to login as
needed.
For your device safety, keep your login password of admin well after the
initialization steps, and change the password regularly.
The IP address of the Device is 192.168.1.108 by default.
environment, and then click Next.
Configuring Account Settings.
21