Figure 123 Basic Services; Table 53 Basic Service Parameters - Honeywell Performance Series User Manual

Figure 123 Basic Services

2. Select Basic Services and configure parameters.

Table 53 Basic Service Parameters

Parameter
Mobile Push
Notifications
CGI
ONVIF
NTP Server
SSH
Enable Device Discovery
Authentication Mode
3. Click Apply to complete the settings.
802.1x
The device needs to pass 802.1x certification to enter the LAN.
1. Go to Main Menu > Security Center > System Service > 802.1x.
Performance Series Embedded NVR User Guide
There might be safety risk when Mobile Push
Notifications/CGI/ONVIF/SSH/NTP Server is enabled.
Description
After enabling this function, the alarm triggered by the NVR can be
pushed to a mobile phone. This function is enabled by default.
If this function is enabled, the remote devices can be added through
the CGI protocol. This function is enabled by default.
If this function is enabled, the remote devices can be added through
the ONVIF protocol. This function is enabled by default.
After enabling this function, a NTP server can be used to
synchronize the device. This function is enabled by default.
After enabling this function, you can use SSH service. This function
is disabled by default.
After enabling this function, the NVR can be found by other devices
trough searching.
•
•
The 802.1x interface is displayed.
Security Mode (Recommended): Uses Digest access
authentication when connecting to NVR.
Compatible Mode: Select this mode when the client does not
support Digest access authentication.
109