Honeywell Performance Series User Manual page 80

Parameter
Default Ethernet
Port
IP Version
MAC Address
DHCP
IP Address
Subnet Mask
Default Gateway
DNS DHCP
Preferred DNS
56
Description
need to configure a default Ethernet port (usually the
Ethernet port 1 by default) to request the services
from the device end such as DHCP, email and FTP. If
one of the two Ethernet ports is disconnected as
detected by networking testing, the system network
status is regarded as offline.
•
Fault Tolerance: Two Ethernet ports share one IP
address. Normally only one Ethernet port is working
and when this port fails, the other port will start
working automatically to ensure the network
connection.
When testing the network status, the network is regarded
as offline only when both of the two Ethernet ports are
disconnected. The two Ethernet ports are used under the
same LAN.
•
Load Balance: Two network cards share one IP
address and they are working at the same time to
share the network load averagely. If one of them fails,
the other can continue working normally.
When testing the network status, the network is regarded
as offline only when both of the two Ethernet ports are
disconnected. The two Ethernet ports are used under the
same LAN.
The Device with single Ethernet port does not support this
function.
In the Ethernet Card list, select an Ethernet port as a
default port.
This setting is available only when the Multi-address is
selected in the Net Mode list.
In the IP Version list, you can select IPv4 or IPv6. Both
versions are supported for access.
Displays the MAC address of the Device.
Enable the DHCP function. The IP address, subnet mask
and default gateway are not available for configuration
once DHCP is enabled.
•
If DHCP is effective, the obtained information will
display in the IP Address box, Subnet Mask box and
Default Gateway box. If not, all values show 0.0.0.0.
•
If you want manually configure the IP information,
disable the DHCP function first.
If PPPoE connection is successful, the IP address, subnet
mask, default gateway, and DHCP are not available for
configuration.
Enter the IP address and configure the corresponding
subnet mask and default gateway.
IP address and default gateway must be in the same
network segment.
Enable the DHCP function to get the DNS address from
router.
In the Preferred DNS box, enter the IP address of DNS.
Performance Series Embedded NVR User Guide