Honeywell Performance Series User Manual page 197

Parameter
Post-Alarm
Report Alarm
Send Email
Record Channel
PTZ Linkage
Post-Record
Tour
Log
Alarm Tone
Buzzer
More
5. Click Apply to complete the settings.
Performance Series Embedded NVR User Guide
Description
When the alarm ends, the alarm extended for a period of time. The
time range is from 0 seconds to 300 seconds.
Select the check box. When an alarm occurs, the NVR device uploads
an alarm signal to the network (including the alarm center).
•
This function is for some series products only.
•
You need to set the alarm center first. For details, see
Center.
Select the check box. When an alarm occurs, the NVR device sends an
email to the set mailbox to notify the user.
You need to set the email first. For details, see Email.
Select the check box and select the needed recording channel
(support multiple choices). When an alarm occurs, the NVR device
activates the channel for recording.
You need to enable intelligent recording and auto recording first. For
details, see Schedule.
Select the check box and click Setting to select the channel and PTZ
action. When an alarm occurs, the NVR device associates the channel
to perform the corresponding PTZ action. For example, activate the
PTZ in channel one to turn to the preset point X.
•
Tripwire alarm supports to activate PTZ preset point only.
•
You need to set the corresponding PTZ actions first, see
Control.
At the end of the alarm, the recording extends for a period of time. The
time range is from 10 seconds to 300 seconds.
Select the check box and select the channel for tour. When an alarm
occurs, the local interface of the NVR device displays the selected
channel screen.
•
You need to set the time interval and mode for tour first, see
Tour.
•
After the tour is over, the preview interface is restored to the
screen split mode before the tour.
Select the check box, the NVR device records the alarm information in
the log when an alarm occurs.
Check the box and then select the corresponding audio file from the
drop-down list. System plays the audio file when the alarm occurs.
Refer to File Management
Select the check box to activate the buzzer when an alarm occurs.
Click More to configure remote alarm output. When alarm event is
triggered, the Device links the alarm output ports on camera to trigger
an action, such as triggering an access controller to unlock door.
•
Enable: Select the check box to enable the remote alarm output.
•
Alarm Output: Select the alarm output port as needed. The
displayed ports are obtained by Device capability set.
•
Post-Alarm: When the alarm ends, the camera alarm output
setting returns to the previous status after a period of time. The
range is from 0 seconds to 300 seconds, and it is 10 seconds by
default.
to add audio file first.
Alarm
PTZ
173