Figure 64 3G/4G; Table 33 3G/4G Parameters - Honeywell Performance Series User Manual

Parameter
End IP
Preferred DNS
Alternate DNS
3. Click Apply to complete the configuration.
3G/4G
Make sure that 3G/4G module is installed on the device.
Note: This function is supported on select models.
1. Go to Main Menu > Network > 3G/4G.

Figure 64 3G/4G

2. Configure Parameters.

Table 33 3G/4G Parameters

Parameter
NIC Name
Network Type.
APN, Dial-up No.
Authentication Type
62
Description
Set preferred/alternate DNS server of the DHCP server.
The interface is divided into three main areas:
Zone 1 displays a 3G/4G signal indication.
•
Zone 2 displays 3G/4G module configuration information.
•
Zone 3 displays the status information of the 3G/4G module.
•
Zone 2 displays the corresponding information when the 3G/4G
module is connected, while Zone 1 and Zone 3 will only display the
corresponding content when the 3G/4G is enabled.
Performance Series Embedded NVR User Guide
Description
Select a NIC name.
Select a 3G/4G network type to distinguish between 3G/4G
modules from different vendors.
Main parameters of PPP dial.
Select PAP, CHAP or NO_AUTH. NO_AUTH represents no
authentication for 3G/4G.