Figure 195 Face Detection; Table 78 Face Detection Parameters - Honeywell Performance Series User Manual

Face Detection
The Device can analyze the pictures captured by the camera to detect
whether the faces are on the pictures. You can search and filter the
recorded videos the faces and play back.
The connected camera shall support human face detection function.
1. Go to Main Menu > VA > Parameters > Face Detection.

Figure 195 Face Detection

2. In the Channel list, select a channel that you want to configure
3. In the Type list, select AI by Reorder or AI by Camera as needed.
4. Configure the parameters.

Table 78 Face Detection Parameters

Parameter
Enable
Rule
Schedule
Alarm-out Port
172
The Face Detection interface is displayed.
face detection function.
When AI by Camera is selected, you can enable Face Enhancement
function to improve face detection efficiency.
Description
Click to enable or disable the face detection.
Click Setting to draw areas to filter the target.
You can configure two filtering targets (maximum size and minimum
size). When the target is smaller than the minimum size or larger than
the maximum size, no alarms will be activated. The maximum size
should be larger than the minimum size. Left click to drag the four
angles to adjust the size.
Configure the period and in the set time range, the corresponding
configuration item will be linked to start the alarm.
The alarm device (such as lights, sirens, etc.) is connected to the alarm
output port. When an alarm occurs, the NVR device transmits the
alarm information to the alarm device.
Performance Series Embedded NVR User Guide