Figure 49 Audio/Video; Table 23 Audio/Video Parameters - Honeywell Performance Series User Manual

Figure 49 Audio/Video

2. Configure parameters.

Table 23 Audio/Video Parameters

Parameter
Channel
Smart Codec
Type
Compression
Resolution
Frame Rate (FPS)
Performance Series Embedded NVR User Guide
The Audio/Video interface is displayed.
Description
In the Channel list, select the channel that you want to configure the
settings for.
Enable the smart codec function. This function can reduce the video bit
stream for non-important recorded video to maximize the storage space.
Main Stream: In the Type list, select General/Motion/Alarm.
In the Compression list, select the encode mode.
H.265: Main profile encoding. This setting is recommended.
H.264H: High profile encoding. Low bit stream with high definition.
H.264: Main profile encoding.
H.264B: Baseline profile encoding. This setting requires higher bit stream
compared with other settings for the same definition.
In the Resolution list, select resolution for the video.
The maximum video resolution might be different dependent on your
device model.
Configure the frames per second for the video. The higher the value is, the
clearer and smoother the image will become. Frame rate changes along
with the resolution.
Generally, in PAL format, you can select the value from 1 through 25; in
NTSC format, you can select the value from 1 through 30. However, the
actual range of frame rate that you can select depends on the capability of
the Device.
47