Figure 198 Intrusion-Draw The Detection Rule; Table 81 Intrusion Parameters - Honeywell Performance Series User Manual

Figure 198 Intrusion-Draw the Detection Rule

b. Configure the parameters.

Table 81 Intrusion Parameters

Parameter
Name
Action
Direction
Filter target
AI recognition
c. Press and hold down the left button on the monitoring screen to
d. Click OK to complete the rule setting.
2. Click
3. Select Enable check box and click Apply to complete the intrusion
People Counting
System adopts video image and graphics analysis technology. System
can calculate the entry/exit people amount in the specified zone on the
video. It can generate an alarm when the amount has exceeded the
threshold.
178
Description
Customize the rule name.
Set the intrusion action, including appear and crossing area.
Set the direction to cross the area, including enter, exit and both.
Click
of the area with the mouse.
Each rule can set 2 target filters (maximum size and minimum size), that
is, when the passing target is smaller than the minimum target or larger
than the maximum target, no alarm will be generated. The maximum size
should not be smaller than the minimum size.
Select AI recognition and the system displays alarm target. The default
selection is person and motor vehicle and system automatically identifies
the person and motor vehicle appeared within the monitoring range.
draw the monitoring area.
, you can refer to
setting.
Performance Series Embedded NVR User Guide
to filter the target. Check the blue wireframe and adjust the size
Tripwire to set other parameters.