Setting Iscsi - Honeywell Performance Series User Manual

Parameter
File Size
Picture Upload Interval
Channel
Day
Period 1, Period 2
Record type
3. Click Test.
4. Click Apply to complete the settings.

Setting iSCSI

Internet Small Computer Systems Interface (iSCSI) is a transport layer
protocol that works on top of the Transport Control Protocol (TCP), and
enables block-level SCSI data transport between the iSCSI initiator and
the storage target over TCP/IP networks. After the network disk is
mapped to the NVR device through iSCSI, the data can be stored on the
network disk.
Note: This function is only supported by select models. The actual product
shall prevail.
1. Go to Main Menu > Storage > iSCSI.
90
The system pops up a message to indicate success or failure. If
failed, check the network connection or configurations.
Performance Series Embedded NVR User Guide
Description
Enter the length of the uploaded recorded video.
•
If the entered length is less than the recorded video length,
only a section of the recorded video can be uploaded.
•
If the entered length is more than the recorded video
length, the whole recorded video can be uploaded.
•
If the entered length is 0, the whole recorded video will be
uploaded.
•
If this interval is longer than snapshot interval, the system
takes the recent snapshot to upload. For example, the
interval is 5 seconds, and snapshot interval is 2 seconds
per snapshot, the system uploads the recent snapshot
every 5 seconds.
•
If this interval is shorter than snapshot interval, the system
uploads the snapshot per the snapshot interval. For
example, the interval is 5 seconds, and snapshot interval is
10 seconds per snapshot, the system uploads the
snapshot every 10 seconds.
•
To configure the snapshot interval, go to Main Menu >
CAMERA > Encode > Snapshot.
Select the channel that you want to apply the FTP settings.
Select the week day and set the time period that you want to
upload the recorded files. You can set two periods for each week
day.
Select the record type (Alarm, Intel, MD, and General) that you
want to upload. The selected record type will be uploaded during
the configured time period.