Figure 196 Tripwire-Draw The Detection Rule; Table 79 Tripwire Parameters - Honeywell Performance Series User Manual

Figure 196 Tripwire-Draw the Detection Rule

Table 79 Tripwire Parameters

Parameter
Name
Direction
Filter target
AI Recognition
3. Click
Performance Series Embedded NVR User Guide
b. Configure the parameters.
Description
Customize the rule name.
Set the tripwire direction, including A→B, B→A and A ↔ B.
Click
the area with the mouse.
Each rule can set 2 target filters (maximum size and minimum size), that is,
when the passing target is smaller than the minimum target or larger than
the maximum target, no alarm will be generated. The maximum size should
not be smaller than the minimum size.
Select AI recognition and the system displays alarm target. The default
selection is person and motor vehicle and system automatically identifies the
person and motor vehicle appeared within the monitoring range.
When you select AI recognition by camera, the connected channel shall
support tripwire function.
c. Press and hold down the left button on the monitor screen to draw
the line. The line can be a straight line or a curve.
d. Click OK to complete the rule setting.
.
The Parameters interface is displayed.
to filter the target. Check the blue wireframe and adjust the size of
175