Figure 68 Snmp Interface; Table 36 Snmp Parameters - Honeywell Performance Series User Manual

Note: This function is for some series only.
1. Go to Main Menu > Network > SNMP.

Figure 68 SNMP Interface

2. Configure the settings for the SNMP parameters.

Table 36 SNMP Parameters

Parameter
Enable
Version
SNMP Port
Read Community
Write Community
Trap Address
Trap Port
Read-Only Username
Read/Write Username
Authentication Type
66
the technical support.
The SNMP interface is displayed.
Description
Enable the SNMP function.
Select the check box of SNMP version(s) that you are using.
The default version is V3. There is a risk of select V1 or V2.
Indicates the monitoring port on the agent program.
Indicates the read/write strings supported by the agent program.
Indicates the destination address for the agent program to send the
Trap information.
Indicates the destination port for the agent program to send the
Trap information.
Enter the user name that is allowed to access the Device and has
the "Read Only" permission.
Enter the user name that is allowed to access the Device and has
the "Read and Write" permission.
Includes MD5 and SHA. The system recognizes automatically.
Performance Series Embedded NVR User Guide