Figure 182 Thermal Alarm - Honeywell Performance Series User Manual

System supports thermal devices and receives the alarm signal from it. It
can recognize the alarm type, and then trigger the corresponding alarm
actions.
The system supports fire alarm, temperature (temperature difference)
and cold/hot alarm.
•
•
•
•
•
1. Go to Main Menu > Event > Thermal Alarm.

Figure 182 Thermal Alarm

2. Select a channel and alarm type, enable the thermal alarm
3. Select fire mode and then enable this function (If the alarm type is
•
•
4. Set parameters.
Performance Series Embedded NVR User Guide
Fire alarm: System generates an alarm once it detects there is a fire.
The alarm mode includes Preset and Excluded zone.
Temperature (temperature difference): System triggers an alarm
once the temperature difference between two positions is higher or
below the specified threshold.
Cold/hot alarm: System triggers an alarm once the detected position
temperature is higher or below the specified threshold.
The connected channel shall support temperature test function.
This function is for some series products only. It supports
enable/disable function only. Go to the front-end device to set
corresponding parameters.
The Thermal Alarm interface is displayed.
function.
Fire Alarm). System supports preset mode and zone excluded
mode.
Preset: Select a preset and then enable the function. System
generates an alarm once it detect there is a fire.
Global: System filters the specified high temperature zone. System
generates an alarm once the rest zone has fire.
161