Parameter
Record status
Snapshot status
3. Click Apply to complete settings.
Disk Group
By default, the installed HDD and created RAID are in Disk Group 1. You
can set HDD group, and HDD group setup for main stream, sub stream
and snapshot operation.
Note: If Disk Quota is selected is shown on the interface, click Switch to Disk
Group mode.
1. Go to Main Menu > Storage > Disk Group.
Figure 88 Disk Group Interface
2. Select the group for each HDD group, and then click Apply to save
82
Description
•
Auto: Automatically record according to the record type and
recording time as configured in the recording schedule.
•
Manual: Keep general recording for 24 hours for the selected
channel.
•
Off: Do not record.
Enable or disable the scheduled snapshot for the corresponding
channels.
The Disk Group interface is displayed.
the settings.
After configuring HDD group, under the Main Stream tab, Sub
Stream tab and Snapshot tab, configure settings to save the main
stream, sub stream and snapshot to different HDD group as
selected by you.
Performance Series Embedded NVR User Guide