Table 83 Parameters And Trigger Columns Parameters - Honeywell Performance Series User Manual

d. Click OK.
3. Click

Table 83 Parameters and Trigger Columns Parameters

Parameter
Channel
Enable
Rule Type
Rule
Alarm
Period
Alarm Out
Latch
Alarm Upload
Send Email
Record Channel
PTZ Activation
Delay
180
in both Parameters and Trigger columns, and configure
parameters.
Description
Select a channel from the dropdown list.
Check the box to enable the function.
Select a people counting rule type.
Click RULE to set statistics region, name, direction.
Click Setting to set alarm parameters.
OSD Overlay: Check the box here; you can view the people amount on the
surveillance video.
Entry No.: You can set people entry amount. System can generate an alarm
once the amount has exceeded the threshold.
Exit No.: You can set people exit amount. System can generate an alarm once
the amount has exceeded the threshold.
Remaining No.: You can set people staying amount in the zone. System can
generate an alarm once the amount has exceeded the threshold.
Configure the period and in the set time range, the corresponding
configuration item will be linked to start the alarm.
The alarm device (such as lights, sirens, etc.) is connected to the alarm
output port. When an alarm occurs, the NVR device transmits the alarm
information to the alarm device.
When the alarm ends, the alarm extended for a period of time. The time range
is from 0 seconds to 300 seconds.
Select the check box. When an alarm occurs, the NVR device uploads an
alarm signal to the network (including the alarm center).
•
This function is for some series products only.
•
You need to set the alarm center first. For details, see
Select the check box. When an alarm occurs, the NVR device sends an email
to the set mailbox to notify the user.
You need to set the email first. For details, see Email.
Select the check box and select the needed recording channel (support
multiple choices). When an alarm occurs, the NVR device activates the
channel for recording.
You need to enable intelligent recording and auto recording first. For details,
see Schedule.
Select the check box and click Setting to select the channel and PTZ action.
When an alarm occurs, the NVR device associates the channel to perform the
corresponding PTZ action. For example, activate the PTZ in channel one to
turn to the preset point X.
•
Tripwire alarm supports to activate PTZ preset point only.
•
You need to set the corresponding PTZ actions first, see
At the end of the alarm, the recording extends for a period of time. The time
range is from 10 seconds to 300 seconds.
Performance Series Embedded NVR User Guide
Alarm Center.
PTZ Control.