Honeywell Performance Series User Manual page 201

Parameter
PTZ Linkage
Post-Record
Tour
Log
Alarm Tone
Buzzer
5. Click OK to save the alarm setting.
6. Select the Enable check box and click Apply to complete the
Intrusion
When the detection target passes the edge of the monitoring area, and
enters, leaves or traverses the monitoring area, the system performs an
alarm linkage action.
1. Go to Main Menu > VA > Parameters > Analytics.
1. Draw the detection rule.
Performance Series Embedded NVR User Guide
Description
Select the check box and click Setting to select the channel and PTZ
action. When an alarm occurs, the NVR device associates the channel
to perform the corresponding PTZ action. For example, activate the
PTZ in channel one to turn to the preset point X.
•
•
At the end of the alarm, the recording extends for a period of time. The
time range is from 10 seconds to 300 seconds.
Select the check box and select the channel for tour. When an alarm
occurs, the local interface of the NVR device displays the selected
channel screen.
•
•
Select the check box, the NVR device records the alarm information in
the log when an alarm occurs.
Check the box and then select the corresponding audio file from the
dropdown list. System plays the audio file when the alarm occurs.
Refer to
Select the check box to activate the buzzer when an alarm occurs.
tripwire setting.
In the Type drop-down list, select Intrusion.
a. Click to draw the rule on the surveillance video.
Tripwire alarm supports to activate PTZ preset point only.
You need to set the corresponding PTZ actions first, see
Control.
You need to set the time interval and mode for tour first, see
Tour.
After the tour is over, the preview interface is restored to the
screen split mode before the tour.
File Management to add audio file first.
PTZ
177