Cts Dot1X - Cisco Nexus 7000 Series Command Reference Manual

C Commands

cts dot1x

To enable Cisco TrustSec authentication on an interface and enter Cisco TrustSec 802.1X configuration mode,
use the cts dot1x command. To revert to the default, use the no form of this command.
cts dot1x
no cts dot1x
Syntax Description
This command has no arguments or keywords.
Command Default
Disabled
Command Modes
Interface configuration
Command History
Release
4.0(1)
Usage Guidelines
This command is not supported for F1 Series modules and F2 Series modules.
To use this command, you must enable the Cisco TrustSec feature using the feature cts command.
After using this command, you must enable and disable the interface using the shutdown/no shutdown
command sequence for the configuration to take effect.
This command requires the Advanced Services license.
Examples This example shows how to enable Cisco TrustSec authentication on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# cts dot1x
switch(config-if-cts-dot1x)# exit
switch(config-if)# shutdown
switch(config-if)# no shutdown
This example shows how to disable Cisco TrustSec authentication on an interface:
switch# configure terminal
switch(config)# interface ethernet 2/3
switch(config-if)# no cts dot1x
switch(config-if)# shutdown
switch(config-if)# no shutdown
Command
feature cts
Modification
This command was introduced.
Description
Enables the Cisco TrustSec feature.
Cisco Nexus 7000 Series Security Command Reference
cts dot1x
65