Ipv6 Access-Class - Cisco Nexus 7000 Series Command Reference Manual

ipv6 access-class

ipv6 access-class
To apply an IPv6 access control list (ACL) to a virtual terminal (VTY) line, use the access-class command.
To remove an IPv6 ACL from a VTY line, use the no form of this command.
ipv6 access-class access-list-name {in| out}
no ipv6 access-class access-list-name {in| out}
Syntax Description
access-list-name
in
out
Command Default
None
Command Modes
Line configuration
Command History
Release
4.0(1)
Usage Guidelines
This command does not require a license.
Examples This example shows how to remove dynamically learned, secure MAC addresses from the Ethernet 2/1
interface:
switch# configure terminal
switch(config)# line vty
switch(config-line)# ipv6 access-class acl-ipv6-vty01
Related Commands
Command
ipv6 access-list
line
Cisco Nexus 7000 Series Security Command Reference
434
Name of the IPv6 ACL.
(Optional) Specifies that the device applies the ACL
to inbound traffic.
(Optional) Specifies that the device applies the ACL
to outbound traffic.
Modification
This command was introduced.
Description
Configures an IPv6 ACL.
Configures line access to the device.
I Commands