Ipv6 Port Traffic-Filter - Cisco Nexus 7000 Series Command Reference Manual

I Commands

ipv6 port traffic-filter

To apply an IPv6 access control list (ACL) to an interface as a port ACL, use the ipv6 port traffic-filter
command. To remove an IPv6 ACL from an interface, use the no form of this command.
ipv6 port traffic-filter access-list-name in
no ipv6 port traffic-filter access-list-name in
Syntax Description
access-list-name
in
Command Default
None
Command Modes
Interface configuration
Command History
Release
4.1(2)
Usage Guidelines
By default, no IPv6 ACLs are applied to an interface.
You can use the ipv6 port traffic-filter command to apply an IPv6 ACL as a port ACL to the following
interface types:
• Layer 2 Ethernet interfaces
• Layer 2 Ethernet port-channel interfaces
You can also use the ipv6 port traffic-filter command to apply an IPv6 ACL as a port ACL to the following
interface types:
• VLAN interfaces
You must enable VLAN interfaces globally before you can configure a VLAN interface. For more
Note
information, see the feature interface-vlan command in the Cisco Nexus 7000 Series NX-OS Interfaces
Command Reference.
Name of the IPv6 ACL, which can be up to 64
alphanumeric, case-sensitive characters.
Specifies that the device applies the ACL to inbound
traffic.
Modification
This command was introduced.
Cisco Nexus 7000 Series Security Command Reference
ipv6 port traffic-filter
459