Show Startup-Config Dhcp - Cisco Nexus 7000 Series Command Reference Manual

Show Commands

show startup-config dhcp

To display the Dynamic Host Configuration Protocol (DHCP) snooping configuration in the startup
configuration, use the show startup-config dhcp command.
show startup-config dhcp [all]
Syntax Description
all
Command Default
None
Command Modes
Any command mode
Command History
Release
4.0(1)
Usage Guidelines
To use this command, you must enable the DHCP snooping feature using the feature dhcp command.
This command does not require a license.
Examples This example shows how to display the DHCP snooping configuration in the startup configuration:
switch# show startup-config dhcp
version 4.0(1)
feature dhcp
interface Ethernet2/46
ip verify source dhcp-snooping-vlan
ip arp inspection trust
ip dhcp snooping
ip arp inspection validate src-mac dst-mac ip
ip source binding 10.3.2.2 0f00.60b3.2333 vlan 13 interface Ethernet2/46
ip source binding 10.2.2.2 0060.3454.4555 vlan 100 interface Ethernet2/10
ip dhcp snooping vlan 1
ip arp inspection vlan 1
ip dhcp snooping vlan 13
ip arp inspection vlan 13
switch#
Related Commands
Command
feature dhcp
(Optional) Displays configured and default
information.
Modification
This command was introduced.
Description
Enables the DHCP snooping feature on the device.
Cisco Nexus 7000 Series Security Command Reference
show startup-config dhcp
901