Object-Group Udp Relay Ip Address - Cisco Nexus 7000 Series Command Reference Manual

object-group udp relay ip address

object-group udp relay ip address
To configure an object group that consists of destination IP addresses to which the packets are forwarded, use
the object-group udp relay ip address command.
object-group udp relay ip address object-grp-name
no object-group udp relay ip address object-grp-name
Syntax Description
object-grp-name
Command Default
None
Command Modes
Global configuration
Command History
Release
7.3(0)D1(1)
Usage Guidelines
To use this command, you must enable the UDP relay feature by using the ip forward-protocol udp command.
You can create up to 4096 object groups.
Examples This example shows how to configure the object group:
switch# configure terminal
switch(config)# ip forward-protocol udp
switch(config)# object-group udp relay ip address udprelay1
This example shows how to delete the the object group:
switch(config)# no object-group udp relay ip address udprelay1
Related Commands
Command
ip forward-protocol udp
Cisco Nexus 7000 Series Security Command Reference
524
Specifies the name of the object group.
Modification
This command was introduced.
Description
Enables the UDP relay feature.
O Commands